help in fixing rek'o'kut needed
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
- jeantalban
- Posts: 43
- Joined: Thu Jun 30, 2011 3:38 am
help in fixing rek'o'kut needed
hi, i'm realizing my rek'o'kut motor is dead. it's the original one. anyway i would have had to change it cause of the europower i'm using here (France). any help from anyone to find a new europower reliable motor? i'm also looking for a dc adapter to move my vinylium overhead. any idea will be great cos the person wich i got the piece from did not give me "transformator" or user's manual.
Re: help in fixing rek'o'kut needed
to move the dc motor is very simple
use a laboratory power supply 1-5 volts.
or there is a dc pwm motor controller kit at conrad for around 30 euros.
you need to put on 2 pins of db25 connector.
i think its pin25 and the one oposite pin13.
but have to verify.
f.
use a laboratory power supply 1-5 volts.
or there is a dc pwm motor controller kit at conrad for around 30 euros.
you need to put on 2 pins of db25 connector.
i think its pin25 and the one oposite pin13.
but have to verify.
f.
Re: help in fixing rek'o'kut needed
I would just look for a small table fan. That motor is ac. It plugs in the wall. You may need to file the edge down so its perfectly round. A superior m 1000 should do it. There on ebay. A lot of them. Oh yeah and since you are france. You may need a plug adapter. Universal plug adapter. Hope that helps..