Since retiring I no longer have need of the manual for Westrex 3D II Cutterhead & RA1700 electronics rack. This is a complete copy of the manual I used while maintaining a disc mastering room in Nashville.
It is a clear copy & is in a binder w clear plastic cover; asking $25.00
I can be reached @ <eandwsvcs>
Bill Wilson
- Bill Wilson
- Posts: 5
- Joined: Sat May 09, 2009 3:34 pm
- Location: Central Florida
- blacknwhite
- Posts: 483
- Joined: Thu Apr 24, 2008 2:57 am
- Location: US
Id like to purchase this temporarily for use in the book I'm helping Larry Boden publish, "Basic Disc Mastering 2nd Edition", which will be for the professionals & anyone interested in the disc-cutting proccess.
This Westrex info would be most helpful to pull information from to include in this book.
I would be more than willing to re-sell the Westrex materials after done using it to whomever else may want it, for the same $25 + shipping.
Thanks,
- Bob
This Westrex info would be most helpful to pull information from to include in this book.
I would be more than willing to re-sell the Westrex materials after done using it to whomever else may want it, for the same $25 + shipping.
I could not get that to resolve to a web address with ".com", ".net", etc., so, hoping you get the message here.Bill Wilson wrote:I can be reached @ <eandwsvcs>
Thanks,
- Bob
- blacknwhite
- Posts: 483
- Joined: Thu Apr 24, 2008 2:57 am
- Location: US