Heater wire
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
- plasticpig850
- Posts: 12
- Joined: Wed Jan 06, 2016 2:02 pm
Heater wire
Hi to all,I've not messaged on here for awhile but browsed regular,I have a MSS direct to acetate recording machine,embosses well with polycarbonate blanks, buying some PVC blanks from MY SHANK,main question is about this diagram from Soulbear/kiss the groove about stylus heater,(I hope snapshot uploaded) would like to know the nichrome wire gauge to use,also is it just diamond stylus to cut PVC or can you use alternative styli, big thanks for any help, also nice thank to Soulbear & Ktg for schematics and update, regards Alan
You do not have the required permissions to view the files attached to this post.
Re: Heater wire
Any new stylus you buy should already have heating wire attached. For cutting MyShank blanks your best bet is a diamond stylus. You can try sapphire but it will dull more quickly.
- soeffingodly
- Posts: 273
- Joined: Fri Jan 19, 2018 8:48 am
- Location: Florida, USA
Re: Heater wire
It will have wires like so:
You do not have the required permissions to view the files attached to this post.
"I wasn't lying. Things I said later seemed untrue."
- plasticpig850
- Posts: 12
- Joined: Wed Jan 06, 2016 2:02 pm
Re: Heater wire
Hi rsimms3, good of you for replying, sorry late reply,I have some sapphire needle that have no wire attached,have today bought from myshank a stylus awaiting delivery,they say their wire is 5v/0,5a do you think this can be used on sapphire, regards plasticpig850rsimms3 wrote:Any new stylus you buy should already have heating wire attached. For cutting MyShank blanks your best bet is a diamond stylus. You can try sapphire but it will dull more quickly.