rebuild federal lathe
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
- ROLANDJAYS
- Posts: 287
- Joined: Sun Apr 14, 2013 3:48 am
rebuild federal lathe
We'll see how modern i can make this lathe
You do not have the required permissions to view the files attached to this post.
Re: rebuild federal lathe
Well someone with your past experience should not have any issues completing this task
Have fun !
Have fun !
Re: rebuild federal lathe
I have a Federal with the same lathe setup but minus the built in electronics. Does yours have the same overhead mechanism mine does where it only cuts inside > out? Looking forward to pictures and what you do with it.
- ROLANDJAYS
- Posts: 287
- Joined: Sun Apr 14, 2013 3:48 am
Re: rebuild federal lathe
This one did come with the over head. And platter . It cuts outside in . I doubt the electronic stuff works . Im just going to toss it in the trash
- EpicenterBryan
- Posts: 738
- Joined: Sun Aug 10, 2014 9:01 pm
- Location: Eugene, OR USA
Re: rebuild federal lathe
Really? How about $20 and I'll pay shipping to get it to Oregon (will prepay shipping).ROLANDJAYS wrote:I doubt the electronic stuff works . Im just going to toss it in the trash
You Can't toss this. Someone will need something....
B