- THEVICTROLAGUY
- Posts: 321
- Joined: Thu Feb 28, 2013 3:55 pm
death and burial of poor cock robin / custom edison cylinder
brown wax cylinder...
Re: death and burial of poor cock robin / custom edison cyli
good sound! tell me how it is done the drive ?, do not hear the motor vibration at all
- THEVICTROLAGUY
- Posts: 321
- Joined: Thu Feb 28, 2013 3:55 pm
Re: death and burial of poor cock robin / custom edison cyli
this is a simple machine i built as a cylinder lathe, i have now made hundreds of recordings on this, we have a store on ebay, WIZARDOFMENLOPARK,
http://stores.ebay.com/wizardofmenlopark/
here is the machine, to keep vibration to a minimum i did not mount the motor to the base, it is siting on rubber snubbers and i am using a rubber belt from the motor to the drive pulley on the mandrel shaft. total cost to build this was less than $ 200...
here is an early test / proof of concept...
http://stores.ebay.com/wizardofmenlopark/
here is the machine, to keep vibration to a minimum i did not mount the motor to the base, it is siting on rubber snubbers and i am using a rubber belt from the motor to the drive pulley on the mandrel shaft. total cost to build this was less than $ 200...
here is an early test / proof of concept...
Re: death and burial of poor cock robin / custom edison cyli
thanks very much for your help! I made a belt drive by the idea of Edison, perhaps the best way to damping. Thanks, very ,very nice sound!