Grampian type C - Connecting wires
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
Grampian type C - Connecting wires
I am rebuilding my lathe and don't remember how to connect the wires back to the cutting head. Can anybody please give me a hint?
You do not have the required permissions to view the files attached to this post.
- dubcutter89
- Posts: 360
- Joined: Thu Oct 19, 2006 6:30 am
- Location: between the grooves..
Re: Grampian type C - Connecting wires
Hi Michaela!
Not critical with the type C as it is non feedback.
Just screw back in the 2 wires from the amp into the the 2 terminals at the back of the head (screws from top I think...)
In the perfect universe you want to check the absolute phase of the system, depends on how critical you are...
Hope that helps!
Lukas
Not critical with the type C as it is non feedback.
Just screw back in the 2 wires from the amp into the the 2 terminals at the back of the head (screws from top I think...)
In the perfect universe you want to check the absolute phase of the system, depends on how critical you are...
Hope that helps!
Lukas
Wanted: ANYTHING ORTOFON related to cutting...thx