The Secret Society of Lathe Trolls

SOLD

For sale is a beautiful original Lyrec SM-8/3B turntable Motor for 110/120V 60Hz. It was installed in a VMS70 that came from CBS/Sony. It was not much in use in the past 15 years. Rubber dampers have been replaced. For european use it comes with a Siemens Micromaster Controler + remote for On/Off, 3...

SOLD

Zuma Disccomputer used for Neumann VMS70 Tested and worked with VMS70. It has an internal clock board so it works also with 50Hz in Europe. Input Voltage is 120V. Handbook and Service notes as .pdf. Shipping is free. Can be used as spare unit or to replace an older pitch system. price: 5k€ For more ...

Hello Anyone have something left to sell :

Transco T170xx lacquers.
2016 also welcome
Apollo A170xx
2016 also welcome

unused Styli as well.

greetings

ak

Hi Lukas, thanks for your report. I have not got any T18xxx But all above T/A171xx seem to have problems. They are too dry so heat lamp does not help. Eventually drying them out even more. According to the plant the drying process happened under to low air humidity conditions. So you can set up a ro...

we had this problem here with batch numbers above 100. So : T171xx or A171xx last year we did not had this problem. around 080 seem to be good. around 090 still ok but not great. cutting room should have about 50% humidity. It helps to put the lacquers in a room with about 70-80% humidity. we used a...

Vol.2 please also with 1kHz at 7cm/s. thanks.


Gesendet von iPhone mit Tapatalk

They look great. I am wondering if you could do also the surrounding/housing of the grey LPI meter? One of mine is a bit broken.

greetings

Andreas


Gesendet von iPhone mit Tapatalk

bump up !

anyone ?

hi guys,

thanks for the infos. Yes i think about 600lbs for the lathe itself is
realistic another.
The rack itself is not so heavy. about 100lbs perhaps.

thanks & greetings

andreas

Hello,

i can´t find any information in my documents.
Perhaps somebody here knows the weight of a complete
VMS70 lathe, without the rack ?
We are planning a new room so i need to know.

Thanks for your help.

Andreas

Hello guys,

perhaps someone like to swap his ocular/eypiece with micron scale against
mine which has a mil scale.

Also the diameter ruler. mine has a "inch" scale for a "cm" scale ?

anyone interested please send me PM

thanks

Andreas

ebay starting to suck extremely.

9% fee on all sales ?

Just sold an expesive compressor one day before this new fee started

greetings

ak

hello Aussie, how are you ? As i am not selling these heads and do not want to get involed in any discussions here I would ask Sean W. Davies as he usually have a test head and can tell more about specs etc. Regarding pictures. If i find time i will post one on my homepage in the future. All I can s...

Hello,

i sold two cutterheads for 5000 Euro each.

The other ones i will keep here as spares.

No one more fore sale.

greetings

Andreas

andybee wrote:here is a pic:

http://www.myspace.com/schnittstelle_mastering

this is a version of the pre-version with cooling from outside.
Picture is about 3 years old.

Hello Flo,

i use the NAB Test record record but i also don´t think it is very accurate.
I like to get some copies of that 7"s when it´s pressed.

greetings

Andreas

Schnittstelle
Mastering & Vinylschnitt

what a monster

i remember this lathe too.
I know a guy who checked it out, but it is
not working.
Good luck fixing the control electronics/pitch computer.

greetings

ak