User avatar
jeantalban
Posts: 43
Joined: Thu Jun 30, 2011 3:38 am

wtb vinilium manual

Post: # 26268Unread post jeantalban
Wed Jul 03, 2013 12:21 pm

hi everyone,
i'm looking for the vinilium red overhead manual and ac adapter to motor informations.thx for any positive implications.

User avatar
studiorp
Posts: 753
Joined: Thu Nov 01, 2007 6:55 pm

Re: wtb vinilium manual

Post: # 26272Unread post studiorp
Wed Jul 03, 2013 2:48 pm

Hi, I have the manual.
Send me a private message,thanks.
About the motor, I know only that is a brushless mini motor, 12v I believe.
The motor move the leadscrew with an o-ring and a brass pulley.

User avatar
opcode66
Posts: 2700
Joined: Sun Nov 08, 2009 10:56 pm
Contact:

Re: wtb vinilium manual

Post: # 26273Unread post opcode66
Wed Jul 03, 2013 3:16 pm

I already sent it to him via pm here.
Cutting, Inventing & Innovating
Groove Graphics, VMS Halfnuts, MIDI Automation, Professional Stereo Feedback Cutterheads, and Pesto 1-D Cutterhead Clones
Cutterhead Repair: Recoiling, Cleaning, Cloning of Screws, Dampers & More
http://mantra.audio

User avatar
flozki
Posts: 571
Joined: Fri May 19, 2006 4:40 am
Location: switzerland
Contact:

Re: wtb vinilium manual

Post: # 26274Unread post flozki
Wed Jul 03, 2013 5:06 pm

it is a maxon dc motor with brushes.
as i can remember it is 5Volts. but i will check that.
motor is pwm controlled and the emk voltage measured between the pwm pulses.
so we could made the regulation without additional servo motor....

but the motor can be driven directly by a dc power supply.
very simple.

and well its : vinylium not vinilium haha.

the manual is not from big importance.
but we might opensource the kingston dubplatecutter schematics and software..
not sure yet...

User avatar
djlithium
Posts: 67
Joined: Sun Jun 29, 2008 1:52 am
Location: Vancouver
Contact:

Re: wtb vinilium manual

Post: # 26772Unread post djlithium
Sun Aug 18, 2013 7:59 pm

That would be really cool if you did, along with an electronics parts list much like some of the o909 kits out there on Ebay. Being able to machine the overhead locally where one resides and then pick up say the Caruso head to complete the unit with a self built electronics box/amp would be spiffy and would greatly expand the amount of people out there cutting on their own .
I need a full cutting solution. But would consider parts :)

Post Reply