The Secret Society of Lathe Trolls

Only ONE copy was made before the label decided to scrap the vinyl release and instead of extra bonus songs, there are 4 songs that AREN'T on it! Talk about super duper rare! I hope someone else on here is as amoral as me.... Are those the hidden tracks? You rambling on about the mole people would ...

By chance, does anybody have any info on this motor.

Best
Peter

It sure has, I was searching for it also.

Shame.

Best
Peter

Spiderxdeath wrote:What is the best material for the hose? Brass? If not something else?

Are you speaking of tube from pump to chip jar or from chip to nozzle?

Best
Peter

I tried not to go higher than 5K but I was rejected. I did leave some lithium grease incase they decide to come out

Check with Flo @ Flokason.ch

I might low ball it see what they say. Will give us a better idea of where their head is at.

Best
Peter

Averaging 3/4k for functional VG66, that's just from sales in the past 2 years.

When will this craziness stop

Best
Peter

Not my sale but stumbled across these VG66 amps a couple weeks ago. Might be of use to some here.


https://reverb.com/item/6386117-neumann-2-sets-of-vms-70-cutting-system-amplifier-rack


Best
Peter

Is your stylus been heated??

Best
Peter

I like the late Al Grundy's approach forget about the lathe history and buy it for what it's worth. Been sentimental over a machine, not for me. We have seen too much of that lately. There is some history behind that Scully but I think it's priced relevant to the market demands. Someone with their h...

There is still one doing the rounds on Ebay.

It has been relisted. Be prepared to pay top dollar. Contact Len Horowitz if you are searching for a turnkey system.

Best Of luck in your search.

Best
Peter

What is the mold going to grab onto if it's pressing a 12" record from a 12" stamper?

There is nothing for the stamper to be clamped in.

Best
Peter

Hi Fela,

It should come apart with a bit of effort.

A good cleaning and re-grease of the ratchet solved the issue for me.

Best
Peter

Hi Folks, My kick-starter for the restoration of a Scully LS-76 is now live. For those who don't know this model, there is some details on the kick-starter for those who do... ;). It is a large project and will be time consuming but it would be a shame to let this lathe sit and be forgotten about. I...

With regards to Freight/shipping. I've recently used these chaps into Ireland as recommended by another troll Hands down they beat everyone for cost and were extremely helpful (No packing available) They will pick up the box stick it on a ship and you will look after customs/duty clearance etc your ...

If you think of it this way. If you record analog, mix analog, master analog, cut analogue you have a certified AAA product (Some like AAA release). Plus analog doesn't suffer from any digital conversion's. You will be taking a pure original sine wave to the disc. It's kinda cheating dumping a digi ...

or another option would be to have an extra set of outputs on the last unit in the desk feeding the preview. It'll require a little reverse eng. and replacement for the rear panel. I think there was a Sontec model out there that had an extra set of outputs for disk cutting It wasn't a four channel E...

Am sure you could set a solenoid with a control voltage to drop the head. You will have to experiment with the timing. or you could use a delay circuit and relay to feed the solenoid... might be an easier option.

Best
Peter

Would a small donation be required to advertise in a "store section" might help with upkeep of the forum?? I could be wrong.