The Secret Society of Lathe Trolls

yes , prices are very good

heads are butterfly heads and size is 1/4 inch

For sale
heads block with prelisten head for studer A80

never used : heads are new
has delay path for 33 and 45 rpm @ 7.5 , 15 and 30 inch per second

make offer

thanks
!

For sale
Neumann eq W495 STB
and a pair of neve 3416 line preamps

ask for details

we can send from the DAW a start by midi , but this start is to begin to cut : we have before recording music the lead in time So we have to think to add a kind of pre roll for the lead in time, another solution is than the pitch controller send a midi start to the DAW at the end of the lead in time...

I ordered the chip to farnell , it costs 1.50 euro ! all less than 5 euros

Flo , we have to reasign the pins to make the code working with this chip .

is there other modifications to do ?
thks

[quote="flozki" for the pitch98/13 i will make a usb to I2C version. then i can control almost everything from the computer. watch out for that. and in the meantime use the solution above.[/quote] Very Cool ! , many thanks It can be nice to have also a midi out with Midi start comming from the pitch...

Thanks Paul

I did not know audio house

best
yann

I have the original desk for sale
complete and 100 % original
beautifull
original documentation
located in Paris
make offer

I am looking for a studer A80 1/4 for spare parts

no need of preamps and head block

thks

hello

I am looking to a telefunken M15 for spare parts
1/4 inch

no need of preamps

motors must be in working order

or if someone has a spooling motor as spart

Thanks for the answer .
Best regards
Y.

It is very interesting ,
can you decribe those modules ?
I don t know those references of modules

Thanks

Y.

Merci Flo !!!!!!!!!!

Yes , you can automat that , or doing it manualy ... it is not so much diificult ... you only have to turn a knob ... it is not a such big deal to automate it ... ( I won t do it) To boogievan :Yes , frequencie response change with the diameter , with the speed too ... and not only at , or around , ...

I have been surprised the first time I saw that on the vms 80 , and I did some test of noise. increasing the current with the diameter gives less noise. the heating has not so much effect at the begening of a side , you can cut with nearly no heating and you won t have so much noise , at more than 5...

Hi! The VMS 80 provides variable stylus heating, can be adjusted, let´s say from 0.45 A outside to 0.75 A inside. There is no difference between 45 and 33 RPM. I have never heard of varying stylus heat from the outside diameter to the inside diameter. I always figured that if I adjusted the heat fo...

Andy I check and check again and I have 12 volt and it is fine with 0.45 amp and it si the same on all the 3 neumann lathe I can check and 2 of them are with with original heating power supply . so there is a problem of metering somewhere ... here , but I don t beleive my multimeter is not right , o...

Hi andy Yes , around 12 volt at the head on the vms 66 I check years ago on a a vms80 , and it was also a voltage of 12 volts I still used this voltage and a current of around 0.5 amp if you want to use only 2 watts , you can still make tests with less than 0.2 amps .. personaly I use around 0.45 at...

I use 12 v and 0.45 amp
The vms66 we have is totaly original and the voltage is 12 volts
on the am32b , we use a DC power supply wich can give 2A at 12 volts,